Of course, for a 2-hour-long video, it still look a long time, but at least I knew what I was doing and felt confident about it. Set the duration of time you want ScreenFlow to record Insert a text clip. What could have become hours of painstaking work suddenly became much less stressful. The finished result is a QuickTime or Windows Media movie, ready for. Repeat all this for the remaining transition points, slowly and surely.Watch that the markers move, but the clips remain untouched. Create In and Out Points over the 12-frame transition.(I choose all the clips after the transition point to avoid creating a gap later in the timeline.) I usually drag it 12 frames and use the “Cross Dissolve” transition. Unlock all the clips, then drag all the later clips (as a big group) over the earlier clip to create the transition.Go to the first transition point, where two clips meet.I wondered what would happen if I locked all the clips, then used Ripple Delete on a section of the video between markers-would it move the markers without disturbing the clips? I didn’t, because if I did, then they wouldn’t show up as chapter markers for the index.Īm I really going to have to move the clips, then remember to move every single marker on its own?! 12 frames for each transition? Really?! There was no way I would get this right. Leaving it this way would have looked terrible, but dragging clips around to add transitions doesn’t drag the markers with them unless you create all the markers on the clips themselves. Just before I went to export the final version for upload, I realized that I’d forgot to add transitions between the various clips. I produced over 2 hours of video, complete with chapter markers to export into Subler as an index of the key moments of the video.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |